Information for Authors
Essential feature of the Registered Reports format is that a significant part of the manuscript is assessed prior to data collection. The submission and review process is consequently divided into two stages.
Stage 1: Initial manuscript submission and review
Initial submissions should include the stage 1 manuscript (requirements detailed below) and a brief cover letter. Authors are welcome to first submit presubmission enquiries for advice on the likely suitability of a study as a Registered Report.
Please include a brief scientific case for consideration and an estimated timeline for completing the study if the initial submission is accepted in principle.
This section should include a review of the relevant literature that motivates the research question and a full description of the experimental aims and hypotheses. Please note that following IPA, the Introduction section cannot be altered.
The methods section should include:
- Full description of proposed sample characteristics, including criteria for data inclusion and exclusion (e.g. outlier extraction). Procedures for objectively defining exclusion criteria due to technical errors or for any other reasons must be specified, including details of how and under what conditions data would be replaced.
- A description of experimental procedures in sufficient detail to allow another researcher to repeat the methodology exactly, without requiring further information. These procedures must be adhered to exactly in the subsequent experiments or any Stage 2 manuscript can be rejected.
- Proposed analysis pipeline, including all preprocessing steps, and a precise description of all planned analyses, including appropriate correction for multiple comparisons. Any covariates or regressors must be stated. Where analysis decisions are contingent on the outcome of prior analyses, these contingencies must be specified and adhered to. Only pre-planned analyses can be reported in the main Results section of Stage 2 submissions. However, unplanned exploratory analyses will be admissible in a separate section of the Results (see below).
- Studies involving Neyman-Pearson inference must include a statistical power analysis. Estimated effect sizes should be justified with reference to the existing literature. Since publication bias overinflates published estimates of effect size, power analysis must be based on the lowest available or meaningful estimate of the effect size. For frequentist analysis plans, the a priori power must be 0.9 or higher for all proposed hypothesis tests. In the case of highly uncertain effect sizes, a variable sample size and interim data analysis is permissible but with inspection points stated in advance, appropriate Type I error correction for ‘peeking’ employed, and a final stopping rule for data collection outlined.
- Methods involving Bayesian hypothesis testing are encouraged. For studies involving analyses with Bayes factors, the predictions of the theory must be specified so that a Bayes factor can be calculated. Authors should indicate what distribution will be used to represent the predictions of the theory and how its parameters will be specified. For example, will you use a uniform up to some specified maximum, or a normal/half-normal to represent a likely effect size, or a JZS/Cauchy with a specified scaling constant? For inference by Bayes factors, authors must be able to guarantee data collection until the Bayes factor is at least 6 times in favour of the experimental hypothesis over the null hypothesis (or vice versa). Authors with resource limitations are permitted to specify a maximum feasible sample size at which data collection must cease regardless of the Bayes factor; however to be eligible for advance acceptance this number must be sufficiently large that inconclusive results at this sample size would nevertheless be an important message for the field.
- Full descriptions must be provided of any outcome-neutral criteria that must be met for successful testing of the stated hypotheses. Such quality checks might include the absence of floor or ceiling effects in data distributions, positive controls, or other quality checks that are orthogonal to the experimental hypotheses.
- Timeline for completion of the study and proposed resubmission date if Stage 1 review is successful. Extensions to this deadline can be negotiated with the action editor.
- Any description of prospective methods or analysis plans should be written in future tense
- Optional. Can be included to establish proof of concept, effect size
estimations, or feasibility of proposed methods. Any pilot experiments will be
published with the final version of the manuscript and will be clearly
distinguished from data obtained for the pre-registered experiment(s).
Following stage 1 peer review manuscripts will either be rejected, given the opportunity to revise or offered an in-principle acceptance (IPA). An IPA indicates that the article will be published pending completion of the approved methods and analytic procedures, in addition to a defensible interpretation of the results.
Authors are reminded that any deviation from the stated experimental procedures, regardless of how minor it may seem to the authors, could lead to rejection of the manuscript at Stage 2. In cases where the pre-registered protocol is altered after IPA due to unforeseen circumstances (e.g. change of equipment or technical error), the authors must consult the Editors immediately for advice, and prior to the completion of data collection. Minor changes to the protocol may be permitted according to editorial discretion. In such cases, IPA would be preserved and the deviation reported in the Stage 2 submission. If the authors wish to alter the experimental procedures more substantially following IPA but still wish to publish their article as a Registered Report then the manuscript must be withdrawn and resubmitted as a new Stage 1 submission.
Note that registered analyses must be undertaken, but additional unregistered analyses can also be included in a final manuscript (see below).
Stage 2: Full manuscript submission and review
Authors will be asked to complete their study and resubmit their manuscripts within 12 months of receiving an in-principle acceptance. Failure to meet the agreed timetable may result in a stage 1 manuscript being considered withdrawn.
A stage 2 submission should include the following additions:
- Confirmation in the resubmission Cover Letter that all non-pilot data was collected after the data of IPA, and analysed in the manner previously described. Any unforeseen changes in methods and analyses must be clearly noted.
- Please note that the Introduction cannot be altered from the approved stage 1 submission, and the stated hypothesis cannot be amended or expanded.
Results & Discussion
- The outcome of all registered analyses must be reported in the manuscript, except in rare instances where a registered and approved analysis is subsequently shown to be logically flawed or unfounded. In such cases, the authors, reviewers, and editor must agree that a collective error of judgment was made and that the analysis is inappropriate. In such cases the analysis would still be mentioned in the Methods but omitted with justification from the Results.
- It is reasonable that authors may wish to include additional analyses that were not included in the registered submission. For instance, a new analytic approach might become available between IPA and stage 2 review, or a particularly interesting and unexpected finding may emerge. Such analyses are admissible but must be clearly justified in the text, appropriately caveated, and reported in a separate section of the Results titled “Exploratory analyses”. Authors should be careful not to base their conclusions entirely on the outcome of statistically significant post hoc analyses.
- Authors reporting null hypothesis significance tests are required to report exact p-values and effect sizes for all inferential analyses.
- Raw and processed date must be made freely available in accordance with our data sharing policies.
Please see our Registered Reports submission guidelines for details of the additional Declarations that must be included, as with standard article types
Manuscripts can be withdrawn at the authors’ discretion following in-principle acceptance. However, the journal will publish the manuscript’s proposed title, author names, the abstract from the approved stage 1 submission and a brief reason for the failure to complete the study.